Polyester Light Fitting With Diffuser For Connection To Group Or Central Battery Systems e840 ZB


Sturdy design of high chemical resistance for application in rough industrial conditions:

  • Housing from glass fibred reinforced polyester
  • Polycarbonate diffuser of high impact strength (equal wall thickness: 2,5mm)
  • Highly resistant foamed silicone gasket of dimensional stability that stands for a permanently safe tightness against water and dust
5-27-2014 9-32-00 PM

For connection to central or group battery systems

  • Application: Emergency light fittings powered by central- or group battery systems
  • Design: Same as type e840 but with DC-detection and change-over to 1-lamp operation (emergency mode)

Application: Hazardous areas of zones 1, 21 and 2,22 as standard illumination or as emergency illumination in combination with external power supply units

Housing: Glass fibred reinforced polyester resin

Cover: Clear polycarbonate with internal prisms, hinged

Gasket: Silicone, foamed. reflector, glass fibred reinforced polyester, hinged and removable

Central locking system: Operated by a hexagonal socket key 13mm

Isolating switch: Switching off all poles when the light fitting is opened

Wiring: Electronic ballast with “end-of- life switching-off system”

Connection: Prepared for looping the mains cable on one small side. Terminal L1 + N + PE up to 6mm² max

Cable entries: 3 entries M25 x 1,5 (2 glands,1 of them with plug and 1 screw plug)

Through wiring system: Looping the mains cable at one end of the housing or through wiring up to 5x2,5mm² possible at extra charge

Mechanical installation: 2 suspension hooks (H8V P) or 2 ceiling brackets(15A P), see accessories.